Microsemi SyncSystem 4380A - Diff Command; FTP and Real-Time (Rt) Configuration Files

DOC 4380A
4380A O & M Manual
30
098-00723-000– Jul 2017 Revision 4.0 SyncSystem 4380A O&M Manual
Users can also remove any configuration files that are no longer needed on the system. Use the list
command to bring up a list of the available configuration files and use the delete <filename> command to
remove the desired file. Users must provide the filename of the file to be removed from the system, if not
the system will provide an error message reminding the user to identify the file to be removed.
4380A>delete example
OK
[OK] 2015-08-05T17:19:48Z
4380A>delete
FILENAME
FILENAME Name of file
[ERROR] 2015-08-05T17:19:59Z
CAUTION
Caution: Users can delete the user default file. If this is done and a new user default configuration file is
not saved, the system will use the factory defaults when rebooted, restarted, or power cycled.
Attention: Les utilisateurs peuvent supprimer le dossier de défaut d'utilisateur. Si ceci est fait et un
nouveau dossier de configuration de défaut d'utilisateur n'est pas sauvé, le système emploiera les défauts
d'usine quand rechargé, remis en marche, ou puissance fait un cycle.
2.10.2 Diff Command
The 4380A will track changes to the system settings that have been made and have not been saved. Use the
diff command to provide a complete list of settings that have been modified but not saved. In the example
below the ptdavg has been changed to 20 seconds but not saved. The system will report the current setting
and the saved (original) setting in the report.
4380A>ptdavg 20
[OK] 2015-08-05T17:41:39Z
4380A>diff
[current]
[ptd_port]
[averaging_interval] 20
[original]
[ptd_port]
[averaging_interval] 10
[OK] 2015-08-05T17:41:53Z
2.10.3 FTP and Real-Time (rt) Configuration Files
The 4380A will boot up with the FACTORY ftp | rt log file settings automatically and will continue to use
these settings until any changes to the gps logging functions are made and saved as the user default log
settings (default). This will save the updated logging configuration and the 4380A will use these settings
each time the system is power cycled, rebooted, or restarted. To save the default log file settings simply
type save_logs ftp or save_logs rt. To see if the user settings have been saved use the list_logs ftp or
list_logs rt command to obtain a list of the possible configuration files. If there are no user configuration
files available the system will report no files.
4380A>list_logs ftp 4380A>list_logs rt
default default
or if there are no log settings files,
4380A>list_logs ftp
no files