EasyManua.ls Logo

Microsemi SyncSystem 4380A - 4394 A-Ecl (Pps-Ecl)

Microsemi SyncSystem 4380A
90 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DOC 4380A
4380A O & M Manual
18
098-00723-000 Jul 2017 Revision 4.0 SyncSystem 4380A O&M Manual
[pps_period] 1.000000000000000e+00
[pps_width] 1.000000000000000e-04
[type] pps
[4]
[format] B
[pps_period] 1.000000000000000e+00
[pps_width] 1.000000000000000e-04
[type] pps
[OK] 2015-02-05T20:36:
To verify the card is working properly, use the status hardware:outputs:slots:N command (where N=Slot
#) to obtain the current settings for a particular card.
4380A>status hardware:outputs:slots:5
[ports]
[1]
[status] good
[2]
[status] good
[3]
[status] good
[4]
[status] good
[power] enabled
[type] 4376A
[OK] 2015-02-05T20:27:05Z
2.5.6 4394A-ECL (PPS-ECL)
This module provides two 1PPS outputs. The output types are user selectable/programmable. Users can
change the PPS signal parameters. Valid PPS settings are 1, 10, 100, 1K, 10K, 100K, and 1M PPS. To set
the PPS signal parameters use the pps command:
4380A> pps [slot#] [port#] [pulse period] [pulse width]
The following example sets the PPS on Slot 1, Port 2 to 1PPS and the pulse width to 10µs.
4380A>pps 1 2 1 1e-5
[OK] 2015-08-05T15:52:31Z
The following rules apply:
1. PERIOD - period of pulse in seconds(max of 1, min of 1e-6)
2. WIDTH - pulse width in seconds (minimum of 5e-7)
3. For PPS Rates where the duty cycle is 10 µs or greater the pulse_width must be a multiple of 10
µs, at least 10 µs wide, and at most half the duty cycle of the pulse_period.
4. For PPS rates where half the duty cycle is less than 10 µs, the pulse_width must be exactly one-
half the pulse_period.
The system will generate an error message if the values are not correct or entered improperly.
Usage: <slot#> <port#> <pulse period> <pulse width>
[ERROR] 2015-08-05T15:53:07Z
To verify the settings, use the settings hardware:slots:N command (where N=Slot #) to obtain the current
settings for a particular card.
4380A> settings hardware:slots:1
[4394]
[ports]
[1]
[pps_period] 1.000000000000000e+00
[pps_width] 1.000000000000000e-04
[type] pps
[2]
[pps_period] 1.000000000000000e+00
[pps_width] 1.000000000000000e-05
[type] pps

Table of Contents

Other manuals for Microsemi SyncSystem 4380A