ScanMaker i800 Pro Scanning Guide 7
D. Using the EZ-Lock 4" x 5" Film Holder
To scan 4" x 5" film, use the EZ-Lock 4" x 5"
Film Holder, which can hold up to 2 pieces of
4" x 5" film at a time.
1. Place the 4" x 5" film to be scanned inside the EZ-Lock 4" x 5" Film Holder, as
indicated in the graphics below. The shiny base of the 4" x 5" film should be
facing down, and the emulsion side of the filmstrip should be facing up.
2. Raise the scanner lid, then place the EZ-Lock 4" x 5" Film Holder towards the back
of the scanner, with the loaded film on the scanner glass surface.
b) Place the film face
down into the holder.
a) Push on the side to
open the lid.
c) Pull down the side
to close the lid.
Keep calibration strip
on the glass surface clear
and free of any obstruction
To make sure film scanning performs
correctly, place the holder on the
scan bed, correctly oriented and
showing the side with the Microtek
logo face up. Align the red arrows so
that the holder’s front edge is flush
against the top ruler of the scanner.
“Microtek” logo
To Next Page
Loading...
Need help?
General
Weight and Dimensions
