:LOC-TRIG <disc>
Select local trigger condition. When local
trigger is ON the trigger button on the front
panel can be used to take a measurement,
all other functions being under remote
control.
Parameters:
ON Enable local trigger.
OFF Disable local trigger.
Example: :LOC-TRIG ON
will allow triggering from the front
panel.
Response:
None.
:LOC-TRIG?
Query the local trigger condition.
Parameters:
None.
Response:
The local trigger flag:
1 Local trigger enabled.
0 Local trigger disabled.
:REPeat <disc>
Enable repetitive measurements when unit
is returned to local control.
Parameters:
The required state:
ON Repetitive
OFF Single shot
Example: :REP ON
will set the unit to repetitive mode
when it is returned to local control.
Response:
None.
:REPeat?
Query the trigger status.
Parameters:
None.
Response:
The selected trigger mode.
0 Single shot
1 Repetitive
Example: 1
would indicate that the instrument
will begin repetitive measurements
when returned to local control.
To Next Page
Loading...
