Need help?Do you have a question about the Microtest 6632 Series and is the answer not in the manual?
General| Functions | DC Voltage, DC Current, Resistance, Continuity, Diode Test |
|---|---|
| Accuracy | DC Voltage: ±(0.5% + 2 digits), DC Current: ±(1.0% + 2 digits), Resistance: ±(0.8% + 2 digits) |
| Resolution | Resistance: 0.1Ω |
| Display | LCD, 3.5 digits |
| Power Supply | 9V battery |
Highlights the main capabilities and specifications of the analyzer.
Lists the technical parameters, ranges, and accuracies of the instrument.
Lists accessories and describes instrument front/back panel interfaces.
Explains how to connect GPIB, RS232, LAN, Handler interfaces, and fixtures.
Guides through setting frequency, level, range, speed, bias, and trigger parameters.
Lists all available measurement parameters like RDC, Ls, Cp, Z, etc.
Covers mode setup, delay, averaging, comparison, binning, and file management.
Explains how to set up limits for pass/fail categorization and binning results.
Details how to configure multi-step tests and related parameters like step, frequency, and level.
Covers trigger, delay, ALC, range hold, and other list mode specific configurations.
Covers sweep type, axis, start/stop, speed, trigger, and trace settings for sweeping.
Explains trace display, cursor usage, auto fit, and equivalent circuit analysis options.
Details open, short, load, and cable length correction procedures for accurate measurements.
Covers language, GPIB, RS232, LAN port, and handler interface settings for instrument control.
Provides detailed accuracy charts and formulas for various measurement parameters.
Explains the syntax rules, subsystem trees, and data formatting for instrument commands.
Lists and defines common SCPI commands for controlling the instrument's functions remotely.
To Next Page