36
5.2.9 STATISTICS
Whether to enable the result statistics function located at the bottom-
right corner; <Clear> will reset all PASS and FAIL statistics and
continuing keeping statistics all over again.
5.2.10 TERMINATED AT NG STEP
When TERMINATED AT NG STEP is set as <ON>, the test will be
terminated when any NG is detected during testing.
5.2.11
PRESET
It resets the LIST file as a new List file, all of the steps are deleted.
<TRIGGER MODE:SINGLE>;<TRIGGER DELAY:0mS>;<OUTPUT
IMPED
ANCE:10
0>;
<A
LC:OF
F>;<
BEE
P
W
HEN:O
FF>;
<RAN
GE
HOLD:ON>;<FAIL RETEST:OFF>;<STATISTICS:OFF>.
5.3 CORR.(LIST CORRECTION)
Under the LIST SET or LIST RUN page, list correction and meter correction are
not the synchronize function. It suggests doing List Correction when starting
multi-step testing at the first time or changing any List setup value.
To Next Page
Loading...