EasyManuals Logo

Microtest MICROSCANNER User Manual

Default Icon
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
MICROSCANNER
ENGLISH - 13
activate the blinking Hub light.
The word SIGNAL blinks once every two seconds
right below the word Hub. Go to the wiring closet
to view a light that blinks once every two seconds
at the port to which the cable is connected.
MICROSCANNER detects the kind of hub it is
connected to: 10, 100, or 10/100 alternately will
be displayed right after the word Hub. The
number is followed by the letters F and/or H as an
indication for the hub's full or half duplex capabili-
ties. Descriptions are as follows:
10 H - 10BASE-T
10 HF - 10BASE-T full duplex
100 H - 100BASE-TX
100 HF - 100BASE-T full duplex
100 HF4 - 100BASE-T full duplex, 100BASE-T4
MICROSCANNER also Identifies workstations.
1. Connect the cable to be tested to the MAIN
jack (identified on the unit right above the
modular 8 jack).
2. To display the length screen, press the
MODE key until the word LENGTH appears
on the screen. MICROSCANNER displays
the word PC followed by the length to the
PC.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Microtest MICROSCANNER and is the answer not in the manual?

Microtest MICROSCANNER Specifications

General IconGeneral
BrandMicrotest
ModelMICROSCANNER
CategoryScanner
LanguageEnglish

Related product manuals