3. Plug the USB memory stick into the top panel USB connector.
4. The M32R will wait for the USB drive to become ready and then run a fully-automated firmware update.
5. When a USB drive fails to get ready, updating will not be possible and we recommend switching the console off
/ on again for booting the previous firmware.
6. The update process will take two to three minutes longer than the regular boot sequence.
To Record to the USB Stick:
1. Insert the USB Stick into the port on the RECORDER section and press the VIEW button.
2. Use the second page for configuring the recorder.
3. Press the fifth rotary control under the screen to begin recording.
4. Use the first rotary control to stop. Wait for the ACCESS light to turn off before removing the stick.
Notes: Stick must be formatted for FAT fi le system. Maximum record time is approximately three hours for each fi
le, with a fi le size limit of 2 GB. Recording is at 16-bit, 44.1 kHz or 48 kHz depending on console sample rate.
Block Diagram
To Next Page
Loading...
