Midas PRO6 Quick Reference Guide

Input dynamics processing (D zone) 37
PRO6 Control Centre
Quick Reference Guide
Input dynamics processing (D zone)
Set up compressor and gate dynamics processors using the controls in the input
channel strip’s D zone.
There are four compressors available, corrective, adaptive, creative and vintage, each
with the option of hard knee, medium knee and soft knee.
>> To set up a compressor/limiter
5
3b
3d
3e
3c
3a
4
Hard
1 Press the quick access button in the comp
section. This will select the channel and
open the compressor processing area in the
GUI’s channel strip.
2 Press ON to switch the compressor on.
3 Operate the controls in the D-zone to
adjust the compression parameters, such
as attack and release. You could also set
up a limiter by using a high threshold and a
steep ratio (greater than 5:1).
4 Use KNEE to audition the different
algorithms (hard knee, medium knee and
soft knee).
5 Use MODE to try different compressor
types (corrective, adaptive, creative and
vintage).
D zone
Input fast strip
5
2
1
Medium
Soft

Midas PRO6 Specifications

General

Brand	Midas
Model	PRO6
Category	Recording Equipment
Language	English