13
Midea 7NM20M1
No of Cavities
1
Note
All oven modes described on Page 9 is main functions of the oven.
▲
Please note the following information:
1. The measurement is carried out in the “ECO” mode to determine the
data regarding the forced air mode and the label-class.
2. The measurement is carried out in the “Top & Bottom Heating” mode
to determine the data regarding the conventional mode.
3. During the measurement only the necessary accessory is in the cavity.
All other parts have to be removed.
4. The oven is installed as described in the installation guide and placed
in the middle of the cabinet
5. It is necessary for the measurement to close the door like in the
household, even when the cable disturbs the sealing function of the
gasket during the measurement. To make sure, that there are no
negative effects regarding the disturbed sealing due to the energy
data, it is necessary to close the door carefully during the measure-
ment. It is may be required to use a tool to guaranty the sealing of
the gasket like in the household, where no cable disturbs the sealing
function.
6. The determination of the cavity volume carried out for the usage
“Defrost” as described on page 12. To ensure an e˝cient use of the
oven, all accessories including
Heat Source Electric
Usable Volume
EEICavity
Energy Effciency Class (A+++ to D)
95,9
A
)( TEN L27
14
ENERGY EFFICIENCY ACCORDING
TO EN 60350-1
DATASHEET (EU 65/2014 & EU 66/2014)
PN:16171100A37201
To Next Page
Loading...
