Midea INNERCHEF Series - Troubleshooting 2

22
• Clean the float valve
gasket.
• Replace the float valve
gasket.
• Food debris on the float
valve gasket.
• Float valve gasket
worn-out.
Steam leaks from float
valve.
Solution
TROUBLESHOOTING
Reason SolutionProblem
• Position the sealing ring
well.
• Lightly push the push rod.
• Sealing ring not installed
properly.
• The floater valve clamps
the push rod.
Difficult to close the lid
• Add water and food
according to the recipe.
• Send to the service center
for repair.
• Too little food and water
in inner pot.
• Steam leaks from the lid or
exhaust valve.
Float valve unable to rise
• Install the sealing ring as
required.
• Clean the sealing ring.
• Sealing ring installed
improperly.
• Food debris attached to
the sealing ring.
• Replace the sealing ring.
• Sealing ring damaged.
• Close the lid correctly.
• The lid is not closed
correctly.
Steam leaks from the lid
• Press the float valve
lightly with a chopstick.
• Open the lid after the
pressure is completely
released.
• Float valve in the popped-
up position.
• Pressure exists inside the
cooker.
Difficult to open the lid
Operation of your appliance can lead to errors and malfunctions. The following tables
contain possible causes and notes for resolving an error message or malfunction. It is
recommended to read the tables carefully below in order to save your time and money
that may cost for calling to the service center.