12
Preparation before operation of the water purifier
Installation procedure
ο Setting the installation location
② Disassemble the package
③ Take out water purifier and accessories
④ Connection of water supply tube
⑤ Connection of drain tube
⑥ Open the water inlet valve.
⑦ Turn on electricity
⑧ Water leakage check
⑨ Instruction for use
⑩ Final inspection
⑪ Finish
Setting the installation location
Install it in the room close to the power source, water source and floor drain,
install in a dry place without direct sunlight, and keep away from flammable and
explosive materials.
Keep this machine in a dry and cool place and avoid direct sunshine. Rearward of
the machine shall be at least 25 cm away from the wall. Never put the machine on
paper or foam, which may store water and then cause creepage. Never put
anything flammable beside this machine.
Do not use the machine outdoors or in a place that can be splashed by water.
Fixing guide
WARNING: Please cut off water source before replacing filters. Never plug filters in
water running state.
1. Unpack the product.
2. Put the accessories aside.
3. Take out the quick joint, and install it on the water pipe. Clamps should not be
missed.
To Next Page
Loading...
