After the wire controller resumes the factory parameter setting,
the rotating parameter setting is restored to 10 hours (the
highest and lowest temperature are not set); The compensation
of body temperature is uncompensated; COOL and HEAT/
single COOL mode is restored to COOL and HEAT model;
The temperature range was restored to 16-30°C(60~86°F ) /
17~30°C(62~86°F ) .
Remote receiving function is restored to be eective; The address
of the two-control rst-line controller is restored to the code
switch.
15.Queries and settings
47
To Next Page
Loading...
