Product Features
Page 88
settings.
6. AIR DIRECTION Button: Press this button to change the
swing angle of the louver. The swing angle of the louver
is 6 degree for each press. When the louver swing at a
certain angle which would affect the cooling and heating
effect of the air conditioner, it would automatically change
the swing direction . No symbol will appear in the display
area when press this button. (Not applicable to units
without this function).
7. LED DISPLAY Button: Press this button to clear the digit
display in the air conditioner, press it again to activate it
(Not available for the units without LED display window).
8. FAN SPEED Button: Fan speed will be selected in
following sequence once pressing this button:
9. ON/OFF Button: For turning on or turning off the air
conditioner.
10. TIME ON Button: For time ON setting. Press this button
to activate the Auto-on time setting. Each press will
increase the time setting in 30 minutes increments, up to
10 hours, then at 1 hour increments up to 24 hours. To
cancel the Auto-on time setting, just press the button until
the time setting is 0.0.
11. SLEEP Button: Press this button to go into the Energy-
Saving operation mode. Press it again to cancel. This
function is only can be used on COOL, HEAT and AUTO
mode and maintain the most comfortable temperature for
you.
12. TIME OFF Button: For time OFF setting. Press this
button to activate the Auto-off time setting. Each press
will increase the time setting in 30 minutes increments, up
to 10 hours, then at 1 hour increments up to 24 hours. To
cancel the Auto-off time setting, just press the button until
the time setting is 0.0.
13. LOCK Button(inner located): When you press the
recessed LOCK button, all current settings are locked in
and the remote controller does not accept any operation
except that of the LOCK. Press again to cancel the LOCK
mode.
14. TURBO Button: Active/Disable Turbo function. Turbo
function enables the unit to reach the preset temperature
at cooling or heating operation in the shortest time(if the
indoor unit does not support this function, there is no
corresponding operation happened when pressing this
button.)
3.1.3 RG51F1/E(Standard for Aurora series)
Remote Controller Specifications
Model RG51F1/E
Rated Voltage
3.0V (Dry batteries R03/
LR03×2)
Reaching Distance 8m
Environment Temperature
Range
-5℃~60℃(23℉~140℉)
Buttons and Functions
1. TEMP UP Button: Push this button to increase the
indoor temperature setting in 1℃increments to 30℃
2. TEMP DOWN Button : Push this button to decrease the
indoor temperature setting in 1℃increments to 17℃.
3. MODE Button: Once pressing, running mode will be
selected in the following sequence:
NOTE: No heating mode for cool only type unit.
4. SWING ↕ Button: Used to stop or start horizontal louver
movement or set the desired up/down air flow direction.
The louver changes 6 degree in angle for each press. If
keep pushing more than 2 seconds, the louver will swing
up and down automatically.
To Next Page
Loading...
Need help?
General
