Product Features
Page 90
4. SWING ↕ Button: Used to stop or start horizontal louver
movement or set the desired up/down air flow direction.
The louver changes 6 degree in angle for each press. If
keep pushing more than 2 seconds, the louver will swing
up and down automatically.
5. SLEEP Button: Press this button to go into the Energy-
Saving operation mode. Press it again to cancel. This
function is only can be used on COOL, HEAT and AUTO
mode and maintain the most comfortable temperature for
you.
6. SWING ↔ Button: Used to stop or start vertical louver
movement and set the desired left/right air flow direction.
The vertical louver changes 6 degree in angle for each
press.
7. SELF CLEAN/FRESH Button：Press this button under
COOL or DRY mode, the self clean function is activated.
Under SELF CLEAN mode, the air conditioner will
automatically clean and dry the evaporator and keep it as
fresh for the next operation.
Hold down this button for at least 2 seconds to activate/
cancel FRESH feature.When the FRESH function is initiated,
the Ionizer/Plasma Dust Collector(depending on models)
is energized and will help to remove pollen and impurities
from the air.
8. FOLLOW ME Button: Push this button to initiate
the Follow Me feature, the remote display is actual
temperature at its location. The remote control will send
this signal to the air conditioner every 3 minutes interval
until press the Follow Me button again. The air conditioner
will beep to indicate the Follow Me feature has ended if it
does not receive the signal during any 7 minute interval.
9. RESET Button (inner located): Once the recessed
RESET button is pressed, all of the current settings will
be cancelled and the controller will return to the initial
settings.
10. ON/OFF Button: Operation starts when this button is
pressed and stops when the button is pressed again..
11. FAN SPEED Button: Fan speed will be selected in
following sequence once pressing this button:
12. TIME ON Button: For time ON setting. Press this button
to activate the Auto-on time setting. Each press will
increase the time setting in 30 minutes increments, up to
10 hours, then at 1 hour increments up to 24 hours. To
cancel the Auto-on time setting, just press the button until
the time setting is 0.0.
13. TIME OFF Button: For time OFF setting. Press this
button to activate the Auto-off time setting. Each press
will increase the time setting in 30 minutes increments, up
to 10 hours, then at 1 hour increments up to 24 hours. To
cancel the Auto-off time setting, just press the button until
the time setting is 0.0.
14. LOCK Button(inner located): When you press the
recessed LOCK button, all current settings are locked in
and the remote controller does not accept any operation
except that of the LOCK. Press again to cancel the LOCK
mode.
15. TURBO/FP Button: Active/Disable Turbo function. Turbo
function enables the unit to reach the preset temperature
at cooling or heating operation in the shortest time(if the
indoor unit does not support this function, there is no
corresponding operation happened when pressing this
button.)
Hold down this button for more than 2 seconds during
heating operation(only when the setting mode is HEAT)
will activate 8
O
C heating operation mode. The unit
will operate at high fan speed with the temperature
automatically set to 8
O
C.
16. LED DISPLAY Button: Press this button to clear the digit
display in the air conditioner, press it again to activate it
(Not available for the units without LED display window).
To Next Page
Loading...
Need help?
General
