Midea MDG80-C09 - Page 45

16
OPERATION
Option
Delay
This function is used for delaying the start of the drying programme up to 24 hours.
When the delayed programme starts, the time starts to countdown on the display and
the delay icon blinks.
1. Load your laundry and make sure the machine door is closed.
2. Press the 【On/Off】button,then turn the programme selector knob and select the
desired programme.
3. You can select the 【Anti-Crease】function according to your need.
4. Press the 【Delay】button.
5. Continue to press 【Delay】to select the desired delay time.
6. After the 【Start/Pause】 button is pushed, the dryer is at the run condition. The
drying procedure will be automatically performed when the delay time is over.
7. If you push the【Start/Pause】button again, the delay function will be paused.
8. If you want to cancel the “Delay” function, please press the 【On/Off】button.
Delay
Time
When the【 Warm】 or 【Cool】 or 【Refresh】 programme is selected, the 【Time】
button can be used to adjust the drying time in 10 min. steps.
Time
Intensity
You can adjust the dryness level of the laundry by pressing the【Intensity】button.
1.The intensity function can be activated only before the programme start.
2. Except the 【Cotton Iron】,【Warm】,【Cool】,【Refresh】,【Wool】,
【Delicate】all the other programmes can be the【Intensity】function.
Intensity
Anti-Crease
At the end of the drying cycle, the anti-crease time is 60 minutes (default) or 120 minutes (selected).
The 【Anti-Crease】 light will illuminate when the anti-crease function is selected. This function
prevents the laundry from creases. The laundry can be removed during the anti-crease phase.
Except【Cool】,【Refresh】, 【Wool】all the other programmes provide this function.
Anti-Crease