Midea MFW-1250MV2 User Manual

17
18
No
washing
Abnormal
draining
Abnormal
spin
Identify usual trouble of washer
List of faults and inspection
Faults
Inspection Items
No water
flows in
If the power is off or the fuse is burned out.
If the water supply is cut off or the water pressure is too low.
If the inlet hose is properly connected and the water tap is opened.
If the filtering screen of inlet valve is blocked by dirt.
If the coil of inlet valve is damaged. (The slight electromagnetic
sound is normal phenomenon when the inlet valve is switched on)
If the "Start / Pause" button is pressed after the power
switch is pressed.
If the door lid is closed.
If all clothing piled largely at one side of barrel or the clothing
is excessively placed.
If the washer is not placed in stable condition or it is placed in
inclination state. (The ground is not flat).
If the motor belt is loosened.
Note: During the de spin process, if washing are piled at one side of the spin barrel,
it will cause unbalance of spin barrel resulting in striking. At this moment, the
computer inside the washer will feel this unbalance phenomenon and will automatically
correct it ( fill in water Washing ). However, if unbalance situation is not removed after
continuous three corrections, which means the computer auto-correction can not
resolve the problem. Then the user has to manually and evenly place the clothing
inside the barrel to solve the problem.
When the washer is in trouble, please contact local service office or the sales service
department of our company and the customer should not dismantle the machine without
permission.
If the washer can not work normally, or appear abnormity or alarms, please check and
correct as follows.
If the water drain hose is placed very high.
If the end of water drain hose is sealed in pond.
If the internal rubber ring of drain valve is blocked by dirt.
If the power is off or the fuse is burned out.
If the power supply voltage is too low.
If the water amount reaches to the required water level.
(The washer will not work if the water amount does not reach the
required water level)
If it is set to "Delay" washing mode. (It will only start to work
until the reservation time reached)
Technical specifications
Malfunction display and solutions
When the washer is in trouble, please contact local service office or the sales service
department of our company and the customer should not dismantle the machine
without permission.
If the washer can not work normally, and the abnormal indication is shown in the nixie
tube window or the machine alarms, please check and correct them as follows.
Alarm for water drain time out.
Open the lid after starting
the delay time.Open the
lid when the washer is
spinning.
After treatment
failure, switch
power key again.
600W
240V~/50Hz
0.1Mpa~0.6Mpa
45kg
12.0kg
Rated power
supply
Application
water pressure
Input power
of motor
Rated capacity
of wash and
spinning
Overall
dimensions
(mm)
Net weight

Midea MFW-1250MV2 Specifications

General

Drum capacity	12 kg
Delay start (max)	48 h
Spin-drying class	-
Maximum spin speed	- RPM
Noise level (spin)	- dB
Delayed start timer	Yes
Load balancing system	No
Package weight	53000 g
Drum volume	95 L
Control type	Touch
Loading type	Front-load
Drum material	Stainless steel
Outlet hose length	3 m
Appliance placement	Freestanding
Connected load	600 W
AC input voltage	240 V
AC input frequency	50 Hz
Energy consumption washing per cycle	- kWh

Weight and Dimensions

Depth	625 mm
Width	601 mm
Height	1015 mm
Weight	45000 g