23
Drawer Removal and Reinstallation:
During installation, service, gas conversion, and leveling, it may be easier
to perform the necessary work if the oven door is removed. This makes
the appliance lighter and visibility of anti-tip bracket is improved.
Follow these instructions below to remove and reinstall the drawer.
To remove drawer, fully extend drawer and operate the release levers
on each side while pulling lightly on drawer.
To reinstall the drawer, align the rails on the drawer with the slides on
the range and push drawer in until fully closed. Open and close drawer
to ensure slide rails are operating properly.
IMPORTANT
SAFETY
INSTRUCTIONS
BEFORE
STARTING
INSTALLATION
INSTALLATION
PROCEDURE
CONFIRM
OPERATION
TROUBLESHOOTING
SAFETY
DEFINITIONS
To Next Page
Loading...
