TROUBLE SHOOTING
Light on, but
motor does not
work
The capacitor is damaged.
The internal wiring of motor is cut off/
disconnected. An unpleasant smell
may be produced.
Both light and
motor do not
work
Apart from the above mentioned, check the following:
Connect the wires as per the electric
diagram.
Outlet and the air ventilation entrance
are not tightly sealed.
Take down the outlet and seal with glue.
Leakage from the connection of
U-shaped section and cover.
Take U-shaped section down and seal
with soap or paint.
The blade, if damaged, can cause
vibrating.
The motor is not tightly fastened.
Fasten the motor tightly.
The cooker hood is not tightly fixed.
Fixed the cooker hood tightly.
The distance between the cooker
hood and the cooker top is too large.
Too much ventilation from open doors
or windows.
Choose a new place to install the
appliance or close some doors / windows.
The fixing screws are not tight
enough.
Tighten the fixing screw and make it
horizontal.
The hanging screws are not tight
enough
Tighten the hanging screw and make it
horizontal.