11
Fig.9-1
Fig.9-2
Fig.9-3
Fig.9-4
Fig.9-5
Fig.9-6
Fig.9-7
Fig.9-8
Fig.9-9
Fig.9-10
Fig.9-11
9.2 Steps to install the fan motor assembly
1) Lift the fan motor assembly; make the edges of fan motor
assembly touch the guide rails. It needs to two persons.
(Fig.9-7)
2) Hold the bottom of the assembly, and then push it up along
the guide rails. (Fig.9-8)
3) Once the hole on the fan clapboard is higher than the pin on
the front board, move the assembly to make the pin through
the hole. (Fig.9-9)
4) One person supports the bottom of fan motor assembly;
another one fixes the M8 screws to make the assembly fixed
on the front board. (Fig.9-10)
5) Connect the wires of motor and neaten it.
6) Two persons lift the base of air conditioner, horizontally push
it and make it covered the air conditoner. (Fig.9-11)
7) Install the duct well. (Fig.9-12)
To Next Page
Loading...
Need help?
General
