MCAC-UTSM-201406 Midea R410A Full DC Inverter Split Type Series Technical Manual
88
Avoid the water enter into the wired controller, use trap and putty to seal the connectors of
wires during wiring installation. When under installation, reserve certain length of the
connecting wire for convenient to take down the wired controller while during maintenance.
Wired controller’s front cover installation:
After adjusting the front cover and then buckle the front cover. Avoid clamping the
communication switching wire during installation.
Correct install the back cover and firmly buckle the front cover and back over, otherwise will
make the front cover drop off.
To Next Page
Loading...
Need help?
General
