INSTALLATION STEPS
17
Safety and
Precautions
Installation
Requirements
Installation
Instructions
Dryer Use
Dryer Care
Troublesho
o
ting
For the proper installation, we recommend that you hire a qualified
installer.
Then choose a 3-wire power supply cord with ring
terminals and UL listed strain relief. The 3-wire power
supply cord, at least 4.92 ft. (1.5 m) long, must have 3
10-gauge solid copper wires and match a 3-wire
receptacle of NEMA Type 10-30R, rated 120/240V,
min 10A.
3-Wire system connections
3-wire system instructions:
A. Terminal block screw
B. External ground connector
C. 3/4" (1.9cm) UL-listed strain relief
D. Neutral wire (white or center wire)
3-Wire
receptacle
(10-30R)
STEP 1 Choose the proper location
STEP 2 Connect the electrical wiring
Three wire outlet
Move your dryer to an appropriate location for the installation.
Consider installing the dryer and washer side-by-side, to allow access
to the gas, electrical, and exhaust connections. Place two of the carton
cushion-tops on the floor. Tip your dryer on its side so it lies across
both cushion-tops.
Set your dryer back in an upright position.
•
•
Connect the neutral wire (white or center wire) of the power cord to
the external ground conductor screw.
Remove the two side terminal block screw and connect the other
wires to the outer terminal screws. Be sure to cross the screw through
the terminal ring and tighten the screw.
Tighten the strain relief screws.
Insert the tab of the terminal block cover into your dryer's rear panel
slot. Secure the cover with a screw.
•
•
•
•
AVERTISSEMENT
Ring-type terminals are recommended. If using strip terminals, make
sure they are tightened.
B
C
D
A
To Next Page
Loading...
Need help?
General