22
4
Wrinkle Prevent
Press once to add the wrinkle care step into the operating program.
Press again to cancel selection.
If wrinkle prevent was active, it provides approximately 90 minutes of
intermittent tumbling in unheated air at the end of the cycle to reduce
wrinkling.
The load is already dry, and can be removed at any time during the
wrinkle care cycle.
5
Delay
This function is used for delaying clothes drying time within 24 hours.
The delay time means the program will start after x hours. When
the delay programme starts, the time starts to countdown on the
display and the delay icon blinks.
6
Time Adjust
These buttons are effective only for Manual cycles. Press these buttons
to change the drying time you prefer. Push repeatedly to get your
desired drying time, including 120 minutes,90 minutes, 60 minutes,
30 minutes.
7
Dryness
Press the button to select the dry level, including More, Normal, Less,
Damp. Different dry level will result in different drying time. For clothes
to be ironed manually, a lower dry level should be selected.
Press and hold for 3 seconds to remember your favorite drying cycle,
this cycle will be “My Cycle”.
8
Signal
Press once to stop the buzzer sound. Press again to activate the sound.
Your selection will be kept until next pressing.
9
Damp Alert
This function is useful when you want to take some garments out for
ironing. The unit will beep 10s when the moisture in the clothes is good
for ironing. At this time, you can take those garments out and continue
drying the other by pressing the "START/PAUSE" button once.
NOTE:
The unit will not stop operating if you don't take those garments out
for ironing.
Requirements
Installation
Instructions
Dryer Use
Dryer Care
Troublesho
o
ting
Safety and
Precautions
Installation
To Next Page
Loading...
Need help?
General