28
Dryer
Safety
Operation
Requirements
Parts and
Features
Installation
Instructions
Dryer Use
Appendix
Dryer Care
Troubleshooting
CONNECT INLET HOSES
H o t w a t e r
Co n n e c t d i r e c t l y o r u s e e x t e n s i o n
h o s e w i t h Y c o n n e c t o r
W a t e r I n l e t
CO L D W AT ER S U P P L Y
If possible install the “Y” connector directly, thread the short extension
hose on to the COLD water supply and snug it by hand; then tighten
it another turn with pliers. Thread the “Y” connector to the short
extension hose and snug it by hand; then tighten it another turn with
pliers.
Connect the COLD inlet hose for the washer to the “Y” connector and
snug it by hand; then tighten it another
turn with pliers.
Connect the straight end of a long hose to the other outlet on the “Y”
connector and snug it by hand. Connect the hose’s 90° coupling to the
brass water inlet on the back of the dryer and snug it by hand. Tighten
each connection of the dryer inlet hose another
turn with pliers. Turn
on the water and check for leaks at all connections.
To Next Page
Loading...
Need help?
General