Service manual for Washing Machine
-------------------------------------------------------------------------------------------------------------------------------------------------------
－ 18 －
4.3 Error codes
Alarm for abnormal water
intaking.
Check if the lid is open.
Turn both faucets on fully.
Check if the water pressure is in the range.
Straighten the water inlet hoses.
Disconnect hoses and clean the screens.
Hose filter screens may be clogged.
Alarm for water drain has not
Finished.
Check the fuse or reset the circuit breaker.
Straighten the drain hoses. Eliminate kinked
hoses. If there is a drain restriction, call for
service.
Close the lid and press the Start/Pause
button. For your safety, your washer will not
spin unless the lid is closed.
Check the height of drain hose end.
Close the lid.
The door lock or PCB is failed.
Refer to 4.5 troubleshooting.
The unit is out of balance in
spin operation.
Make sure your washer is set on a level
surface. If the surface is not level, adjust
your washer’s feet to level the appliance.
Make sure your washer is not touching any
other object.
Make sure the laundry load is balanced.
During the spin process, if clothes are piled
at one side of basket, it will stop due to
imbalance. The unit will try to solve the
problem automatically. If the washer can’t
solve the problem in three trials, you should
replace the clothes and make it as even as
possible manually.
The unit is out of balance in
spin operation.
Adjust the water level refer to Installation
instructions. If situation continues, call
service center.
Water leveling sensor failed
Refer to 4.5 Trouble shooting.
To Next Page
Loading...
