Midea Mono 3D - Page 95

93
2
Fan ass’y
How to remove the fan
ass’y.
1) After remove the panel
plate following procedure
1, remove the hex nut
fixing the fan and then
remove the fan.
2) Remove the one fixing
screw. Unfix the hooks and
then open the electronic
control box cover.
3) Release the fan motor
connector and four way
valve connector.
4) Remove the four
fixing screws of the fan
motor.
5) Then remove the fan
motor.
Compressor and
liquid-gas separator
Electronic control box
Nut fixing the fan
Two reactors
Fan