Midea MOU-12HN1

MCAC-UTSM-2008-11 Remote Controller
Control 137
1. Remote Controller
1.1 R11-HG/E
I/O Button
Temperature Button
Each time you push
button, a mode is
selected in a sequence
that goes from AUTO,
COOL, DRY, HEAT
(cooling only type
without), FAN ONLY and
back to AUTO.
the
Push the button to start
operation, push the
button again to stop
operation.
This button is used
for selecting fan speed.
Each time you push
the button, a fan speed
isselectedinasequence
that goes from AUTO,
LOW, MED(Some models
without, HIGH, and back to
AUTO.
Mode select button
Fan button
After Sliding the cover, the button and function are as follows:
This button is used for
setting the current time
and OFF time.
Adjust forwards
Adjust backwords
Push this button to cancel
ON timer and OFF timer.
When you push the RESET
button, all current settings
are cancelled and get into
the condition of beginning.
In the clock, the colon in
"0:00" will flash, the mode
displays"AUTO",fanspeed
displays "AUTO", the
temperature displays "24".
Push ON-TIME timer
button to set the ON timer.
Push OFF-TIME timer
button to set the OFF timer.
Auto louver button
Push this button to swing
louver. Push the button
again to stop.
Push this button to confirm
ON and OFF timer settings.
Confirmation button
Clock button
Push this button to set
time.
When you push the LOCK
button, all current settings
are locked in and the remote
controller does not accept
any operation except that of
the LOCK button. Use the
lock mode when you want to
prevent setting from being
changed accidentally or play
fully. Push the LOCK button
again when you want to
cancel the LOCK mode.
FAN
Timer button
RESET button
Lock button