Why does my Midea Room air conditioner keep resetting?
If your Midea Room air conditioner frequently resets during operation, it could be due to a defective indoor PCB. To resolve this, replace the indoor PCB and then check if the failure persists. Another potential cause is problems with the power supply circuit. In this case, replace the indoor fan motor and check if the issue is resolved.
What does it mean when the Operation lamp is on and the Timer lamp flashes on my Midea Room air conditioner?
If the Operation lamp is on and the Timer lamp flashes on your Midea Room air conditioner, it indicates an EEROM error or a defective indoor PCB.
General| Brand | Midea |
|---|---|
| Model | MSG-30CR |
| Category | Air Conditioner |
| Language | English |
Instructions to prevent injury and damage.
Warnings for installation and operation.
Electrical schematic diagram of the unit.
Wiring diagrams for different modes and models.
Torque specifications for installation fittings.
Procedure for purging air from the refrigerant system.
Procedure for pumping down refrigerant during re-installation.
Procedure for re-purging air after re-installation.
Procedure for balancing refrigerant levels.
Procedure for evacuating the refrigerant system.
Procedure for charging refrigerant into the system.
Troubleshooting guide for cooling and heat pump modes.
Diagnostic flowchart for troubleshooting.
Troubleshooting for frequent resetting during operation.
To Next Page
