What to do if the Operation lamp is off and the Timer lamp flashes on my Midea Air Conditioner?
If the Operation lamp is off and the Timer lamp flashes, this may be because of an EEROM error or a defective indoor PCB. The suggested solution is to replace the indoor PCB.
What to do if over current protection of the compressor occurs 4 times in Midea Air Conditioner?
If the over current protection of the compressor occurs 4 times, you should inspect the compressor and its operation.
What to do if the Operation lamp and Timer lamp both flash on my Midea Air Conditioner?
If the Operation lamp and the Timer lamp are both flashing, the suggested solution is to replace the main control board.
What to do if the indoor room temp sensor is open circuit or short circuit in Midea MSG-30CRN1-QB9P Air Conditioner?
If the indoor room temperature sensor is open circuit or short circuit, you should test the indoor room temperature sensor.
What to do if the indoor room temperature or evaporator sensor is open or short circuit on a Midea Air Conditioner?
If the indoor room temperature or evaporator sensor is open circuit or short circuit, you should inspect and test the temperature sensors.
What to do if the temperature sensor on the indoor evaporator is open circuit or short circuit in Midea Air Conditioner?
If the temperature sensor on the indoor evaporator is open circuit or short circuit, you should test the indoor evaporator temperature sensor.
What to do if the indoor fan speed has been out of control for over 1 minute on my Midea MSG-30CRN1-QB9P Air Conditioner?
If the indoor fan speed has been out of control for over 1 minute, you should check the indoor fan operation.
General| Cooling Capacity | 3.0 kW |
|---|---|
| Heating Capacity | 3.2 kW |
| Power Supply | 220-240V, 50Hz |
| Refrigerant | R32 |
| Type | Split System |
To Next Page
