Midea MWMWT080CR2A - Page 20

19
Installation
Instructions
15
4. Install Air Conditioner
A. While keeping a firm grip on the air
conditioner, carefully place the unit into
the window opening so the bottom of
the air conditioner frame is against the
window sill (Fig. 5). Carefully close the
window behind the top rail of the unit.
Fig. 5
window
frame
Fig. 6
Fig. 7A Fig. 7B
A. Place the frame lock between the
frame extensions and the window
sill as shown (Fig. 7A for Wooden
windows), (Fig. 7B for Vinyl-Clad
windows). Drive 3/4” (19 mm) or 1/2”
(12.7 mm) locking screws through the
frame lock and into the sill.
NOTE: To prevent window sill from
splitting, drill 1/8” (3 mm) pilot holes
before driving screws.
B1:
For wooden windows:
Drive 1/2” (12.7 mm) locking screws through the
top rail and into the window sash (Fig. 8A).
NOTE: To prevent window sill from splitting, drill
1/8” (3mm) pilot holes before driving screws.
Drive 1/2” (12.7mm) locking screws through frame
holes into window sash (Fig. 8B).
B. Extend the side panels out against the window
frame (Fig. 6).
5. Secure Air Conditioner
Fig. 8A
NOTICE
Check that air conditioner is tilted back
per dimension H (Fig. 5) (tilted about
3° to 4° downward to the outside).
After proper installation, condensate
should not drain from the overflow
drain hole during normal use. Adjust
the slope if otherwise.
Wooden Windows
INSIDE
OUTSIDE
H: About 3/4” to 1”
Measure from the cabinet edge
Vinyl-Clad Windows
INSIDE
OUTSIDE
H: About 3/4” to 1”
Measure from the cabinet edge
(for 8K)
(for 8K)