midiplus minicontrol User Manual

MIDIPLUS Co, Ltd.
6
http://www.midiplus.com.tw
(5) 5.1 Restore factory parameter function
At the same time, press the ” TAP””SET” “A/B” three keys, as shown in the figure
below red box button. Panel key lights, flicker phenomenon that success set to restore
the factory parameter. If equipment anomalies or MIDI information through the MIDI
Editor software, after the modification of the MIDI value at the same time you press the ”
TAP””SET” “A/B” three key parameters can restore the factory.
5.2 Minimum System Requirements
If you are using your minicontrol with a computer, the following minimum system
requirements need:
Windows
Mac OS
Pentium 3 800MHz or higher
Macintosh G3*800/G4*733MHzor higher
CPU requirement may be higher laptops
CPU requirement may be higher for laptops
256 MB RAM
OS X 10.3.9 with 256MB RAM
Direct X 9.0b or higher
OS X 10.4.2 or greater with 512 MB RAM
Windows XP(SP2) or higher
*G3/G4 accelerator cards are not supported.
Windows 98,Me,NT or 2000 not supported
(Attention: Window98/ME or 2000 are not supported)
MIDIPLUS suggests that you connect directly to your computer built in USB ports.

midiplus minicontrol Specifications

General

Brand	midiplus
Model	minicontrol
Category	Recording Equipment
Language	English