16
5.1 MANUAL RECOIL START
1. Set the On/Off switch on the right handlebar to the ON position
2. Set the choke lever to the START position.
3. Push the primer bulb 6 times, waiting 2 seconds between each push. Stop
when you see the fuel owing from the fuel tank to the carburetor through
the transparent hose.
4. Pull recoil handle out rapidly, to start the engine. Carefully allow the recoil
handle to return. Repeat this step until the engine starts.
5. Move the choke lever to the RUN position when the engine warms.
NOTE
For restarting a warm engine:
1. Move the ON/OFF switch to the ON position
4
5