19
7. USING THE TILLER
7.1 ADJUSTING THE DEPTH REGULATOR
WARNING!
Always release the throttle lever back to the neutral position and
stop the engine before adjusting the depth regulator.
Adjust the depth regulator up one hole at a time, testing tiller
operation after each change. Raising the depth regulator too
drastically can result in losing control of the tiller.
Tilling height is controlled by the height of the depth regulator. The higher the hole
on the depth regulator, the shallower the tilling.
1. Remove the pin securing the depth regulator.
2. Raise or lower the depth regulator to the desired height. Secure in place
with the pin.
Depth
Regulator
HH0407
To Next Page
Loading...