EasyManuals Logo

Midland BENCHMARK HH0407 User Manual

Midland BENCHMARK HH0407
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
3
causing personal injury or property damage.
Watch for holes, roots, bumps, or other rough ground. Tall grass can
hide obstacles.
Always look behind and down and use caution when using reverse or
pulling the tiller towards you.
Never attempt to start the tiller unless both wheels are locked in the
same position.
Always start the tiller on the level surface.
Do not till up a slope greater than 10 degrees.
DO NOT attempt to till hard soil, till too deep or till at an overly fast rate
that can overload the tiller.
Always be sure of your footing. A slip and fall can cause serious
personal injury. If you feel you are losing your balance, release the
control lever immediately and the tine will stop rotating.
DO NOT till near drop-offs, ditches, or embankments, you could lose
your footing or balance.
After striking a foreign object, stop the engine, disconnect the spark
plug wire and ground against the engine. Thoroughly inspect the tiller for
any damage. Repair the damage before starting and operating the tiller.
1.3 MAINTENANCE SAFETY
WARNING!
Turn off the engine before performing any maintenance. Failure to do so
can cause severe personal injury or death.
Use rubber gloves when coming into contact with engine oil.
After any maintenance is performed, wash immediately using soap and
clean water. Repeated exposure to lubricant may cause skin irritation.
DO NOT clean the lter element with ammable liquids like gasoline; an
explosion may occur.
Allow the tiller to cool down before performing any maintenance.
Always stop the tiller before removing the oil ller cap.
To reduce the re hazard, keep the engine and gasoline storage area
free of grass, leaves, or excessive grease.
Drain the fuel tank outdoors only.
Tiller components, guards, and shields are subject to wear and damage
which could expose moving parts or allow objects to be thrown.
Frequently check components and replace immediately with original
equipment manufacturer’s (O.E.M.) parts only, listed in this manual.
HH0407

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Midland BENCHMARK HH0407 and is the answer not in the manual?

Midland BENCHMARK HH0407 Specifications

General IconGeneral
BrandMidland
ModelBENCHMARK HH0407
CategoryTiller
LanguageEnglish

Related product manuals