EasyManua.ls Logo

Midland BENCHMARK HH0408 - Page 23

Midland BENCHMARK HH0408
110 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
2. Unscrew one of the oil dipsticks and clean the dipstick.
3. Check the oil level by reinserting the oil dipstick without screwing it back in.
Remove the dipstick and examine the oil level. If the level is at or below
the minimum oil level marked on the dipstick, rell to the maximum oil level
mark.
4. Reinsert the dipstick and tighten securely.
NOTE
Max oil capacity: 17 . oz / 500mL
SAE 10W-30 oil is recommended for general use.
DO NOT OVERFILL.
4.2 CHECK THE FUEL LEVEL
WARNING!
Gasoline is highly flammable and explosive under certain
conditions. Refuel in a well-ventilated area with the engine
stopped. DO NOT smoke or allow open flames or sparks in
the area where the tiller is being refueled or where gasoline
is stored. DO NOT overfill the tank. Be careful not to spill fuel
when refueling. Wipe up any spilled gasoline and let the area dry
before starting the engine.
Gasoline substitutes such as gasohol are not recommended.
They may be harmful to the fuel system components.
1. Check the fuel level by removing the fuel tank cap to visually check the
level.
2. Add fuel carefully. DO NOT ll up to the base of the fuel neck. Fill the fuel
tank no closer than 1 inch from top of tank to provide space for expansion.
Fill until 1 inch
below the top of the neck
Fuel Cap
OPEN
Fuel Capacity: 0.3 Gal / 1.2 L
Oil Drain Bolt
HH0408

Table of Contents

Related product manuals