Midland BENCHMARK HH0408 - Using the Tiller; Adjusting the Depth Regulator

25
7. USING THE TILLER
7.1 ADJUSTING THE DEPTH REGULATOR
WARNING!
Always release the clutch lever back to the neutral position and
stop the engine before adjusting the depth regulator.
Adjust the depth regulator up one hole at a time, testing tiller
operation after each change. Raising the depth regulator too
drastically can result in losing control of the tiller.
Tilling height is controlled by the height of the depth regulator. The higher the depth
regulator is set, the shallower the tilling.
1. Remove the linchpin.
2. Raise or lower the depth regulator to the desired height. Secure in place
with the linchpin.
e off the spark arrester from the muffle
the engine cool down.
8.7.1••••Remove••the••fuel••cap••and••filter.
8.7.2••••Clean••the••filter••with••solvent••
8.7.3••••Wipe••the••filter••and••insert••it.
8.7) Cleaning••Fuel Tank••Filter••
the spark arrester from the muffle
engine cool down.
8.7.1••••Remove••the••fuel••cap••and••filter.
8.7.2••••Clean••the••filter••with••solvent••
8.7.3••••Wipe••the••filter••and••insert••it.
8.7) Cleaning••Fuel Tank••Filter••
e muffle
8.7.1••••Remove••the••fuel••cap••and••filter.
8.7.2••••Clean••the••filter••with••solvent••
8.7) Cleaning••Fuel Tank••Filter••
8.7.1••••Remove••the••fuel••cap••and••filter.
8.7) Cleaning••Fuel Tank••Filter••
8.6.2)Take off the spark arrester from the muffle
after the engine cool down.
8.6.3)Use a brush to remove carbon deposits from the
spark arrester . If the spark arrester is wear,
replace it.
8.7.1••••Remove••the••fue
8.7.2••••Clean••the••filter
8.7.3••••Wipe••the••filter••a
8.7) Cleaning••Fu
Linchpin
Linchpin
e off the spark arrester from the muffle
the engine cool down.
8.7.1••••Remove••the••fuel••cap••and••filter.
8.7.2••••Clean••the••filter••with••solvent••
8.7.3••••Wipe••the••filter••and••insert••it.
8.7) Cleaning••Fuel Tank••Filter••
the spark arrester from the muffle
engine cool down.
8.7.1••••Remove••the••fuel••cap••and••filter.
8.7.2••••Clean••the••filter••with••solvent••
8.7.3••••Wipe••the••filter••and••insert••it.
8.7) Cleaning••Fuel Tank••Filter••
e muffle
8.7.1••••Remove••the••fuel••cap••and••filter.
8.7.2••••Clean••the••filter••with••solvent••
8.7) Cleaning••Fuel Tank••Filter••
8.7.1••••Remove••the••fuel••cap••and••filter.
8.7) Cleaning••Fuel Tank••Filter••
8.6.2)Take off the spark arrester from the muffle
after the engine cool down.
8.6.3)Use a brush to remove carbon deposits from the
spark arrester . If the spark arrester is wear,
replace it.
8.7.1••••Remove••the••fue
8.7.2••••Clean••the••filter
8.7.3••••Wipe••the••filter••a
8.7) Cleaning••Fu
Linchpin
Linchpin
HH0408