Midland BENCHMARK HH0408 - Page 27

23
5.1 MANUAL RECOIL START
1. Move the ON/OFF switch to the ON position.
2. Push the primer bulb 3 times, waiting 2 seconds between each push.
3. Pull recoil handle out slowly. Once tension is felt on the rope, pull recoil
handle out rapidly, to start the engine.
NOTE
 For restarting a warm engine:
1. Move the ON/OFF switch to the ON position
2. Pull the recoil handle slowly until resistance is felt, then pull rapidly
until engine starts. Allow recoil handle to return. Repeat until engine
starts.
1 2 3
1 2
1
1 2 3
1 2
1
HH0408