Midland BIZTALK BR200 - Page 6

midlandusa.com
6
||
Read a programmed BR200 so you can:
• Use the same programming values for other BR200 radios.
• Save the programming file for later use.
• Check the settings to make sure they are correct and match other radios.
10. Turn the radio off and disconnect the programming cable.
11. Turn the radio on, and test it with other radios to make sure it is working correctly.
12. Write the program to other BR200 radios, or save and close the program.
1. Follow steps 1 through 5 above to connect the radio to the computer and open the software.
2. Click on the red “R” icon.
3. The programming data will automatically be read from the radio and populate the window.
4. Click “OK” to confirm and complete the process.
5. The radio will return to its normal state when complete.
a. Click on the green “W” icon.
b. The programming data will automatically be sent to the radio.
c. Click “OK” to confirm and complete the programming.
READ A PROGRAMMED BR200
TIP: If the radio does not successfully program, go the the Trouble Shooting section of the instructions.
!
W
R