7
||
midlandusa.com
1. Follow steps 1 through 5 above to connect the radio to the computer and open the software.
2. Use the “Open Folder” icon to locate and open your file.
1. Follow steps 1 through 5 above to connect the radio to the computer and open the software.
2. Set all programming settings to their default values.
a. Click on “Edit”.
b. Click on “Default Settings”. This will automatically populate all settings with the default value.
PROGRAM USING A SAVED FILE
RESET A RADIO TO ITS FACTORY DEFAULT SETTINGS
6. The programming data will be displayed on their respective program window.
7. Turn off the radio and disconnect the programming cable.
8. With the programming software still open, connect another BR200 radio follow step 9 above to write the
same data to additional radios.
9. Or, save your file for later use and close the program.
Open Folder
Edit
3. The file will automatically populate all settings with the data saved in your file
4. Click on the green “W” icon as described in step 9 above to program the radio.
5. Disconnect the radio and test it with other radios to make sure it is operating correctly.
3. Click on the green “W” icon as described in step 9 above to program the radio.
4. Disconnect the radio and test it with other radios to make sure it is operating correctly.
To Next Page
Loading...
