CT710 Instruction Guide | 13
MENU → A VFO/MR → C
ENTER → B Tasto laterale 2 → D
DTMF programmed by software
(see the instructions of the Programming software)
Once the optional call signaling DTMF function is programmed on the
desired channels, press the flank key2 and the display will show DTMF.
Now you can input the 8-digit DTMF codes.
If the input number is wrong and you want to change it, rotate the en-
coder.
Counterclockwise rotation delete one by one, clockwise to exit the DTMF
function. Input your desired number, press PTT key to make a call. When
your partner receives the correct code, the programmed DTMF function
or the radio identification will be done.
ANI PTT-ID Operation
ANI means Automatic Numbering Identification.
You can set an automatic number identifier visible from the radio’s di-
splay of your partner each time you send a call signal. This function must
be activated on both radios and must be programmed by software (see
the instructions of the Programming software).
To Next Page
Loading...
