CT710 Instruction Guide | 5
Main functions
• Dual band (VHF/UHF) displayed
• Frequency band:144-146MHz & 430-440MHz (Rx / Tx).
• Working mode: UHF-VHF, VHF-VHF or UHF-UHF
• Output power: 5W VHF /4W UHF
• 128 stored channels
• Scrambler (levels can be programmed via software)
• Compander (programmable via software)
• VOX function
• 210 DCS codes and 50 CTCSS tones
• “VOICE” function
• SOS emergency function
• Channel spacing selectable between 25kHz and12,5 kHz
• Following options can be shown on the display: channel name +
channel number, channel number + frequency, channel number, or
frequency
• Inverted frequency function
• Scan function
• FM radio receiver
• Frequency Step: 5 kHz, 6.25 kHz, 10 kHz, 12.5 kHz, 25 kHz,
• Selectable tx power: high (4-5W)or low (1W)
• Li-Ion battery pack 1600mAh
• Frequency Offset: 0-69.950 MHz
• Shift repeater
• ”Busy channel lockout” frequency (programmable via software)
• Tx signal strength indicator on the display
• Low battery vocal indication
• Roger Beep tone at the beginning or end transmission
• TOT (Time out timer)
• Keypad lock
• Scan of frequencies with CTCSS/DCS
• Scan priority
• DTMF
• Reset of functions and channels
• 1750 / 1450 / 2315 tone to connect to repeaters (programmable via
software)
• Jack for external speaker/mike: 2 Pin KENWOOD type
To Next Page
