CT710 Instruction Guide | 19
scanning.
Frequency or channel scan
In channel /frequency mode, press MENU and 1SCAN: the radio will scan
from current channel through all the channels and, whenever any signal
is detected, the radio will stop scanning for 8 seconds. Then press PTT to
transmit: it will then continue to scan after 8 seconds.
Press any key except PTT to end scanning: the radio will return to the
channel or frequency in use before starting the scan function.
Priority channel scan
Priority scan means that the radio starts scanning from the priority chan-
nel first and then scans the other channels. For example, if the priority
channel is 1, the scan will be 1-2;1-3;1-4;…….
Procedure:
In channel mode ,press MENU and 2PRI: the radio will scan priority chan-
nel, whenever any signal is detected, the radio will suspend the scan for
8 seconds, then press PTT key to transmit. It will then continue to scan
after 8 seconds.
Press any key except PTT key to end scanning.
VOX Sensitivity Setting
This function allows hand-free communications: you activate the
transmission when you speak to the microphone without pressing the
PTT button. It stops transmitting automatically once you stop speaking.
The sensitivity can be adjusted in different levels that can be set upon
your needs.
Procedure:
In Frequency mode, press MENU and 3VOX keys: the screen will display
“003 VOX?”.
Press ENTER and the display will show “VOX OFF”.
To adjust the desired sensitivity level, press any number key (0-9) on the
keypad or rotate the encoder.
To confirm your selection press ENTER and VFO/MR to exit.
Power Setting (high or low)
With this function you can select the power level, you can choose betwe-
en High (H) and Low (L).
To Next Page
Loading...
