14 | CT710 Instruction Guide
Shortcuts Operation
MENU + 0 ANI setting
MENU + 1 scan mode
MENU + 2 priority scan mode (only in VFO mode)
MENU + 3 VOX Sensitivity setting
MENU + 4 output power setting
MENU + 5 SQ adjust
MENU + 6 scrambler on/off setting
MENU + 7 backlight on/off setting
MENU + 8 backlight color setting
MENU + 9 beep on/off
MENU + # receive and transmit CTCSS/DCS setting
MENU + * S-D +/- potential difference setting
Cloning Function
This function allows to copy all data/settings (programming) from a radio
to another one, without using PC. Turn off both radios and connect the
optional cloning cable to the radio ‘master’ (radio to be copied) and to the
radio ‘slave’ (radio to program). Turn on the radio ‘master’ while keeping
pressed the PTT button at the same time. The display will show CLONE?.
Press PTT once. Turn on the radio ‘slave’ within 10 seconds. The display of
the radio ‘slave’ will show PC and the led on the front will start flashing
green. At the end of this procedure, the radio ‘slave’ will be rebooted and
will turn on with the new programmed data. During the programming,
the radio ‘master’ will show CLONE on the display and the green led will
blink. When all data have been copied, END will appear on the display.
Repeat the same procedure for further programming procedures.
To Next Page
Loading...
