CT310 Instruction Manual | 7
Installing / Removing the Li-ion Battery
Match the two grooves of the battery pack with the corresponding guides on
the back of the transceiver and push.
1. Press the battery pack and transceiver firmly together until the release
latch on the top of the transceiver locks. After hearing a “click” sounds, the
battery has been locked.
2. To remove the battery pack, slide the release latch and remove the pack
away from the transceiver.
Installation & Connection
Installing / Removing the Antenna
Installing the Antenna:
Screw the antenna into the connector on the top of the transceiver by holding
the antenna base and turning it clockwise until secure.
Removing the Antenna:
Turn the antenna counterclockwise to remove it.
Installing / Removing the Belt Clip
Installing the Belt Clip:
Place the belt clip to the corresponding grooves on the back of the transceiver,
and then turn the screws clockwise.
Removing the Belt Clip:
Turn the screws counterclockwise to remove the belt clip.
Installing Optional Speaker / Microphone
Unveil the MIC-SP jack cover and then insert the Speaker/ Microphone plug
into MIC-SP jack.
Note: The transceiver is not completely waterproof while using the Speaker/
Microphone.