CT310 Instruction Manual | 17
Frequency/Channel Scan
Under corresponding mode, press FUNC, the top left corner of the LCD displays
icon, then press SCAN to start the frequency scan or channel scan.
1. Frequency Scan
In VFO mode, the frequency scan is available. This function is used for
monitoring signal of various communication frequency by transceiver
‘step’ setup, press numeric key or ESC key to exit.
2. Channel Scan
Under channel mode, this function is used for monitoring signal of each
channel in this mode. Press numeric key or ESC to exit.
NOTE:
Frequency scan is of all bands scan, it scans upwards as your STEPPING
setting.
In channel scan, the skipped channel is not in the line of scanning. Scan
upwards as per channel no. (please refer to channel scan skip).
Frequency/channel scan can change the scan direction by rotating the channel
switch, when find a matching carrier wave and signaling, the transceiver will
stay 5 seconds then re-starts scanning. (Please refer to scan setup)
Channel Scan Skip
In channel mode, press FUNC , the top left corner of LCD displays icon,
then press SKIP to set the current arrow directed channel as Channel scan
skip. Repeat the above operation to cancel the channel scan skip.
1. LCD displayed “S” means the current channel will not be scanned.
2. “S “ icon disappeared means the current channel will be scanned.
Frequency Reverse
In standby mode, press FUNC, the top left corner of LCD displays icon,
then press REV to set the arrow indicating the channel as frequency reverse,
repeat above operation to turn o the frequency reverse.
1. When LCD displays “R” icon, it means that the arrow shows the channel
of the frequency reverse function; the TX frequency and RX frequency is
interchanged, as well as the CTCSS/DCS (if set).
2. When “R” icon disappears, it means reverse function is deactivated.