22 | CT310 Instruction Manual
9 TALKAR Talk Around
TX=RX
Turn on Talk Around function, current channel will transmit at RX frequency, if
CTCSS/DCS signaling is set, it will interchange decoding CTCSS/DCS as encoding.
OFF Close Talk Around function.
10 OFFSET Oset Frequency setup 0-70MHz Frequency range is 00-70MHz.
11 NAME Editing Channel name a-Z In channel name display mode, the edited channel name will be displayed.
12 RPLOCK Busy Channel Lockout
BUSY Carrier wave lock, transmitting is prohibited when received matching carrier wave.
REPEAT
Signaling lock, transmitting is prohibited when received matching carrier but with
mismatching CTCSS/DCS.
OFF
Close BCLO function.
13 TX TX OFF
ON TX function is enabled in the current channel.
OFF TX function is disabled in the current channel.
14 BAND Band Limit ON/OFF Turn on/o band limit function.
15 DSPSUB Sub band display setup
FREQ Display sub band frequency or channel
VO LT Display current battery voltage
OFF
Sub band display is disabled
16 BEEP Keypad Voice prompt setup ON/OFF Turn on/o the keypad voice prompt function
17 TOT Time-Out-Timer
OFF Turn o time-out timer
1-27MIN
Total 27minutes of TOT for optional, each interval is 1minute
18 VOX
Voice Operated Transmission
(VOX) Setup
OFF
Turn o the VOX function
1-10 Total 10 VOX levels as option
19 VDELAY VOX Delay Setup 0.5S-3S Total 27 levels available, each interval is 0.1S
20 APO Automatic Power O Setup
OFF Disable the Automatic power o function
30MIN-2HOUR 30minutes ~ 2hours: Total 3 levels available.
21 DTMF
DTMF
Transmitting Time
50MS-500MS Total 5 kinds of DTMF transmitting time available
22 SQL Squelch level Setup 00-09 10 levels of squelch available, “00” is minimum setup value (normally open)