Midland E+READY ER310 - Dynamo Power; Solar Panel Charge; AA Battery Operation

M_o_d_ei_E_R_3_10
_____________
~~IDLAND
ER31
0 Power Sources Continued ...
Dynamo Power:
Turning the hand crank charges the built-in
Li-ion battery pack. To charge the radio using the hand crank,
make sure the power source switch is
in
the
"Li" position and start
turning the crank. The CHARGE indicator
light will be lit while
the unit is being cranked. Speed
of
cranking and length
of
time
cranked
will
determine the charge
of
the Li-ion battery. The battery
icon on the
LCD will flash
as the battery charges. When the Li-ion
battery has reached
full
charge, the battery icon
will stop flashing
and will have 3 bars.
One
minute
of
cranking gives up to 9 minutes
of
radio use time.
Solar Panel
Charge:
Make sure the power source switch is
in
the "Li"
position. Then,
place
the
ER31
0 where the solar panel
is
exposed to direct sunlight.
One
hour
of
solar
charging
in
optimal
sunlight conditions gives up to 45 minutes
of
radio use time. The
battery icon on the
LCD will flash
as the battery charges. When
the Li-ion battery has reached
full charge, the battery icon will
stop
flashing and will
have 3 bars. The CHARGE indicator
light will be
lit while the unit is charging.
AA Battery Operation:
The
ER310
is designed to operate
on six AA batteries (not included). To power the
ER31
0
on
its
AA
batteries, flip the power source switch to the
"AA"
position.
Warning: For long-term storage, it is recommended that the
AA
batteries be removed to prevent leakage and damage to
the ER310.
midlandusa.com
Page 7