Midland FLM60H - User Manual

Questions and Answers

D
Daniel BlairSep 8, 2025
Why is my Midland Lawn Mower engine sluggish at switch on?
- B
  barronkatieSep 9, 2025
  If the engine of your Midland Lawn Mower is sluggish at switch on, the possible causes are: * Accelerator not in start-up position. * Choke not closed. * Petrol does not arrive. * Air bubbles or water inside the petrol lines. * Thick oil prevents rotation. * Winding or start mechanism faulty. * Spark plug in poor condition. To resolve this: 1. Move the accelerator to the intermediate position. 2. Close the choke when cold. 3. Check the fuel tank and remove any water or sediment. Make sure that the feed cock is open. 4. Check the lines and bands. Repair or replace if damaged. 5. Use oil with a viscosity suited to the temperature. 6. Replace winding or start mechanism. 7. Clean or replace spark plug. Adjust the distance between the electrodes.
B
Brent SawyerSep 12, 2025
Why are the exhaust fumes bluish from my Midland FLM60H?
- M
  Maria OlsonSep 12, 2025
  If the exhaust fumes from your Midland Lawn Mower are bluish, it could be due to: * Too much engine oil * Elastic bands worn To fix this: 1. Restore engine oil to correct level 2. Replace elastic bands
S
suzanne01Sep 12, 2025
Why does the silencer become red through overheating on my Midland FLM60H?
- D
  duncanvalerieSep 13, 2025
  If the silencer on your Midland Lawn Mower becomes red through overheating, it could be due to: * Air filter blocked * Inside of self-winding starter blocked with grass cuttings To resolve this: 1. Clean air filter 2. Clean self-winding starter housing
M
Michael WilliamsSep 14, 2025
Why does my Midland FLM60H Lawn Mower tend to run away on steep banks?
- J
  jamesweaverSep 15, 2025
  If your Midland Lawn Mower tends to run away on steep banks, it may be because: * The ground is too soft. * The operator is cutting at right angles to the bank. To address this: 1. Wait until the ground dries. 2. Work in the direction of the bank.
X
xnashSep 17, 2025
Why does the cutting unit of my Midland FLM60H Lawn Mower project objects outwards?
- C
  Chad DennisSep 17, 2025
  If the cutting unit of your Midland Lawn Mower projects objects outwards, it's likely because: * The front guard is raised. * The front cover is open. * You're working in reverse gear. To prevent this: 1. Lower the front guard. 2. Close the front cover firmly. 3. Only work in forward gear.