Page 9 www.midlandradio.com
GXT600/650 SERIES QUICK REFERENCE CHART
MONITOR
Pressing and holding the MONITOR button for 1 second will let you
hear noise so you can adjust the volume level of the radio when not
receiving a signal. This should be used to check activity on your
current channel before transmitting.
Press and hold the MONITOR button for 1 second again to get out
of MONITOR mode.
SCAN
Your GXT600/650 Series can scan all 22 channels for activity. To
enter, quickly press the SCAN button. Repeat the same procedure to
exit. Your radio will rapidly scan each of the 22 channels and stop on
any active channel for 5 seconds before resuming scan.
When you press the PTT button to transmit on an active channel, the
scanning function will stop and remain on the active channel.
To resume scanning, quickly press the SCAN button.
CALL TONE
Your GXT600/650 Series can transmit a call tone for a fixed length of
time. To send a call tone, press the CALL button. The TX icon will
appear while transmitting a call tone and a tone can be heard on the
speaker for confirmation.
The GXT600 has 5 Call Tone selection while GXT650 has 5 “Animal
Sound” Call Tone.
Model GXT600/650 Series
To Next Page
Loading...
Need help?
General
