10 | M Zero Plus Instruction Guide
NOTE: shouting into the mic will not increase your power or signal. An internal circuit
automatically sets the mic signal for maximum modulation, so speak loudly will give
no advantage.
SELECTION OF Po/St BANDS
1. Turn on the radio while keeping pressed the UP/DOWN controls
2. With the UP / DOWN buttons select the desired band: Po = Poland (40 Ch
AM/FM - 26.960/27.400) - St =Europe (40 CH AM/FM - 26.965/27.405)
3. Push PTT to exit the selection
QUICK SCROLL
To scroll the channels, keep pressed the UP or DOWN controls for 6 seconds.
KEYPAD BEEP
When this function is enabled, you will hear a beep tone everytime a button is pressed.
To activate/deactivate the beep tone:
1. keep pressed the UP button while turning on the radio;
2. press UP or DOWN to enable/disable the beep;
3. when the beep tone is enabled, the display will show ‘ON’ and when it’s disa-
bled, ‘OF’ will be displayed.
EMERGENCY CHANNEL MEMORY
The emergency channel set by default is channel 19; to change it, follow these steps:
1. move the knob of the CH/EMG selector to EMG position;
2. the current emergency channel blinks on the display;
3. press the UP / DOWN controls for 5 seconds at the same time. The display
will stop blinking;
4. with the UP/DOWN buttons select the new emergency channel;
5. push again UP / DOWN for about 5 seconds;
6. the display will blink again and will indicate the new emergency channel me-
mory.
To Next Page
Loading...
Need help?
General
